Page 1 of 1

B.Bearings

PostPosted: Fri May 25, 2012 12:33 am
by higgi20m
So I just got my Isis, played with it a little bit till I got the ten clues. I just figured them all out.

But I have one issue, I hear nothing in my Isis. It is dead silent. So is this normal or did something happen to it? And I have now tried clue 11 on it but still nothing happened. Am I just to gentle? Or is it not suppose to be like this. I just really want to get started but I don't know how to start if I don't hear anything.

Also the bottom silver ring is lifted off a little bit and I think I can see a bb. Is that normal too?

I don't want clues on how to open it, I just want to know if this is normal or not, and if its not how do I fix it and get it to the starting stage? (I tried surfing the different topics but I kept reading more then I wanted to know so I'm sorry if this is a repeat topic)
Its my graduation present and I just really want to get started.

Re: B.Bearings

PostPosted: Mon Feb 04, 2013 7:23 pm
by pacmanmentos
I have also figured out all the clues and one of them states that you can clearly hear 2 BB at all times yet I hear none :( I try to twist and shake my way to BB noises yet nothing.

Re: B.Bearings

PostPosted: Mon Feb 04, 2013 9:08 pm
by Pyromancer
With the button upwards, give the Isis a shake in a circular fashion and you should hear the two BB's rolling around.

There is a spring loaded BB under each ring that makes them click as they are rotated, these are not the BB's refered to in the clues.

Re: B.Bearings

PostPosted: Wed Feb 06, 2013 10:53 pm
by redlaymerej
I am having the same problem. I just received the titanium and gold isis. I do not hear anything on the inside. I have been shaking it in a circular motion for at least ten minutes. I still hear nothing. Any other suggestions?

Re: B.Bearings

PostPosted: Thu Feb 07, 2013 12:10 am
by Pyromancer
Try listening in a quiet room.

Hold it to your ear if need be.

Shake it harder.

That's all I can suggest - hope you hear something soon.

Re: B.Bearings

PostPosted: Thu Feb 07, 2013 1:15 am
by JRBigBird
Mine could get wedged sometimes, especially if the placetas weren't even. Give it a little bump with the heel of your hand on the plunger side. Mine would make a noise and then the bearings were free again.