Page 1 of 1

Problems resetting isis

PostPosted: Mon Feb 20, 2012 4:55 am
by KKSigs
Hope someone can help. I just opened my isis and wrote down the number however when trying to reset it I ran into problems. When I screwed back the isis together, the placentas are now 180 degrees from each other and cannot for the life of me to get the top ball bearing to fall in the maze. Did I screw my isis up? Any help would be appreciated. Dumb thing is that I never took a pic of my isis open. I didn't even know of this forum until I started looking for help on the internet to put back the isis back properly. Thanks in advance

Kevin

Re: Problems resetting isis

PostPosted: Mon Feb 20, 2012 11:06 pm
by evilkeen
Hi there and welcome!

You have a PM!

Re: Problems resetting isis

PostPosted: Tue Feb 21, 2012 1:43 am
by KKSigs
PM sent thanks

Re: Problems resetting isis

PostPosted: Tue Feb 21, 2012 1:46 am
by evilkeen
Yay, welcome to the 5% club!

Re: Problems resetting isis

PostPosted: Fri May 11, 2012 10:10 pm
by carlmcleod
Did you find a solution for this?
Just got mine open - logged the number inside, tryed to put it back together and its locked at 180.
Be gratefull for any help resetting