Isis Stuck

[gusgunis]

Hello all,

I am a newbie. I deciphered the clues and found clue 11 on the forums. i believe i was at the halfway mark and was able to separate the placentas a centimeter. I released the plunger and now i am not able to move the Isis at all, also i am able to press the plunger all the way in now. i can hear the larger BB moving slightly, and if i shake hard enough i can hear the smaller one.

Can someone let me know if i jammed it? or how to reset it, Help!!

[evilkeen]

Hi there, I have sent you a PM

[gusgunis]

Thanks evilkeen!! that is what i figured... now to get it unstuck!

[gusgunis]

I got it open!!! woo hoo...

[evilkeen]

[madig2000@gmail.com]

Good evening,. I believe I'm in the "limbo" reset issue stage as well,.

I opened the Isis last week (and have the key registered on the website),.then reassembled it fine a couple times,./ but this last time I didn't get it completely closed,. teh placenta's are about 180 degrees apart with a 1 mm space between the top ring,. Is here a way to reset/reopen it without damaging it?

Much thanks in advance

Madi..

[fr4n]

Hi folks

My Isis got stuck in reset limbo on the first go. The placentas are stuck 45 degrees apart with a 2 or 3 mm gap.

Any advice is much appreciated!

[evilkeen]

Hi and welcome!

You have a PM, good luck getting unstuck!

[madig2000@gmail.com]

Hi and welcome!

You have a PM, good luck getting unstuck!

Stuck as well,. see previous post above,.. thanks in advance,.

[evilkeen]

OK, you have a PM too (sorry you should have had one sooner!)...

[KKSigs]

I am in the same predicament. Anyone please help. The placentas are 180 degrees from each other and I can't get the top bearing to drop by hitting it

[evilkeen]

All depends on its current state - you have a PM anyway!

[Cwoodard]

I'm at the same spot, placentas are 180 degrees with a small gap between pieces please help

[brett]

Hi there,

I also managed to get my isis stuck in the process of screwing it back together. It just stopped mid-way. This thread suggests there is a solution to this issue. Will someone share it with me?

Thanks
Brett

[evilkeen]

Did you manage to get a picture of it open for access to the 5% club? You'll find some info in there... If not, drop me a PM.